咨询热线

15901301202

分享中心

可拆卸式保温套的安装方式

来源:   发布时间:2018-08-10

在安装可拆卸式保温套时,
1.要检察阀门和管道保温是否符合安装条件,
2.检察保温套外表是否完好。
3.需要测量接口尺寸并在保温套外壳上画出轮廓线。
4.沿轮廓线切割,完成后打开保温套修整缺陷。
5.将保温套扣在被保温阀门上,拧紧螺栓,完成安装。
When installing a detachable insulating sleeve,

1., to check whether the valve and pipe insulation meets the installation conditions.
2. the inspection of the heat insulation cover is perfect.
3. it is necessary to measure the size of the interface and draw contours on the housing.
4. cut along the contour line, and then open the insulation sleeve to repair defects.
5. button the thermal insulation sleeve on the insulated valve, tighten the bolt and complete the installation.

安装可拆卸式保温套的注意事项:
1.由于施工现场情况复杂,未使用产品前不要将产品的包装打开,以免造成污染或者碰撞。
2.安装产品时,要将产品置于干净平整的工作垫上,应避免拖拽,防止产品表面产生划痕。
3.产品安装完成后,在正式投产前,应使用防尘布等加以覆盖,以免其它工种作业时造成污染或损坏。
4.再次拆装时,要有顺序的将拆下的保温套放在事先铺好的清洁垫上,注意保护产品编号清晰,以免安装时找不到对应位置。
The precautions for installing the detachable insulating sleeve are:

1. due to the complexity of the construction site, do not open the product package before the product is used, so as not to cause pollution or collision.
2. when installing products, place products on clean and smooth work mats, avoid dragging and prevent scratches on the surfaces.
3. After the product is installed, it should be covered with dust-proof cloth before putting into production, so as to avoid pollution or damage caused by other types of work.
4. again when disassembly, there should be a sequence of dismantled thermal insulation on the pre laid clean pad, pay attention to the protection of the product number clear, so as not to find the corresponding position when the installation.
上一篇:可拆卸保温套的优势 下一篇:可拆卸式保温套如何选择才是最合适的
分享到:
在线客服
热线电话

咨询:15901301202

返回顶部

版权所有 :北京博锐科仪高温材料有限公司,主营产品:保温套保温夹套。  技术支持:蓝杉互动